Error type: LCD error code: T_****. L_****
When there is LCD error code like T_*** and L_**** series, it is mostly the issue of LCD hardware issue.
the error code can be mixed because of several issues happen together.
define LCD_ERROR_SD2828_0 0x01
define LCD_ ERROR _SD2828_1 0x02
define LCD_ ERROR _FPGA_CONF 0x04
define LCD_ ERROR _MIPI_DSI_ERROR 0x08
define LCD_ ERROR _MIPI_DISPLAY_OFF 0x10
define LCD_ ERROR _FPGA_VERSION_LOW 0x20
define LCD_ ERROR _MIPI_NO_SCREEN 0x40
define LCD_ ERROR _MIPI_AUO_L055 0x80
Troubleshooting:
1. Confirm your workflow when error reported, do you replace a new screen?
2. Check if all the wires relate to LCD and the board connect well
3. Check if the screen model is right, and a wrong FPGA firmware can also be blame. (the different screen may request different adaptors,
please check the manufacture if you are going to use a different LCD screen, also chitu website has a list about which screen has been supported)
4. Try to connect another LCD if you have on hand, to check if the new screen is DOA(Dead on arrival)
Feel free to send your error code picture to suppor@cbd-3d.com. It will help us completes the knowledge base.

T_08
2K LCD signal errors, reboot the board

T_40
watchdog timeout, reboot the printer

T_80
2K LCD signal errors (TWICE), reboot the mainboard or re-adjust the wiring connector of the 2k LCD screen to the mainboard

T_88
2K LCD signal errors (TWICE),

T_100
NO TE signal for 2K LCD,

T_120

L_10

T_88 L_0

T_100 L_0

T_100 L_10

T_100 L_40
